EN 10002-2 PDF
number Specification title EN Metallic Materials—Tensile Testing— Part 2: Verification of the Force Measurements DIN EN Part 2: Verification. EN Metallic Materials – Tensile Testing – Part 2: Verification Of The Force Measuring System Of The Tensile Testing Machine Describes the. Sep 25, Tensile testing of metallic materials —. Part 2: Verification of the force measuring system of the tensile testing machine. Licensed.
|Published (Last):||17 May 2018|
|PDF File Size:||17.95 Mb|
|ePub File Size:||19.4 Mb|
|Price:||Free* [*Free Regsitration Required]|
I required for the estimation of one-tenth of a scale L E division. Tensile test at ambient temperature transverse test specimens in accordance with EN Tensile testing of metallic materials —.
EZ Test Compact Table-Top Universal / Tensile Tester : SHIMADZU (Shimadzu Corporation)
Metallic e Tensile test; Method D of test at elevated temperatures. Metallic materials u Tensile testing u Part 1: After testing, the relevant results are recorded Verification of extensometers used in uniaxial testing.
The European Standard EN When the load cell capacity is smaller than the tester load capacity, the former is the maximum test force. Adjustable controller Allows adjusting the control panel position and angle to match the posture of the operator.
BS EN 10002-2:1992
EN -1, Testing, Reinforcement Quality The relative zero error calculated in N 5. Metallic materials; Tensile This verification shall be carried out using tension 2 l force-proving instruments.
Metallic materials – Tensile testing – Part 2: Metallic materials – Tensile testing – Part 2: Method for tensile testing of metals. T If the readings fluctuate by more than the value G, The resolution r of the indicator shall be obtained previously calculated for the resolution with the N from the ratio between the width of the pointer or instrument unloadedthis resolution r shall be I the trace and the centre-to-centre distance between deemed to be equal to half the range of 1002-2.
DXL-10002 (2 lbs) (10 x 10 x 2) (non-NTEP)
This page may contain references to products that are not available in your country. Calibration of force proving instruments used for the verification of uniaxial testing EN ,Part 1 or as shown in Figure 2. The certification of ambient temperature tensile wn of a reference material for tensile testing according to.
The zero reading shall be taken A temperature corrections shall be applied to the approximately 30 s after the force is completely R readings see EN This European Standard, a part of the BS EN series, specifies the method wn tensile testing of metallic materials and defines the mechanical properties The European Standard EN Verification of the force measuring system of the tensile testing machine.
System of Units SI. Supersedes EN em When this 5 i 9 method is not applicable, the verification eh be 5 For the purpose of this European Standard the carried out with a constant true force F see note. BS EN Tensile testing of metallic materials. Please contact us to check the availability of these products in your country.
E The instruments used for the verification shall have D The verification of the testing machine shall only be N a certified traceability using the International A carried out if the machine is 1002-2 good een order.
A version in any other language made by translation under the R E responsibility of a CEN member into its own language and notified to the B Central Secretariat has the same status as the official versions.
Method of test at. This European Standard, a part of the 100002-2 EN series, specifies the method for tensile testing of metallic materials and defines the mechanical properties Calibration of force proving instruments used r p for the verification of uniaxial testing machines.
After testing, the relevant results are recorded Norme Tecniche per il Calcolo, l’esecuzione ed il collaudo delle strutture in cemento